Black gutter run fixed along a white fascia board under a tiled roof, family run roofers offering guttering and fascias

Family Run Fylde Coast Roofers

Guttering & Fascias in Lytham St Annes

Every joint, bracket and board on a Fylde coast roofline has to stand up to salt, sand and strong winds.

  • A free quote and no obligation
  • Our owner started roofing at 17
  • A guarantee on all our work
  • Working across the Fylde coast

Your Free Roof Quote

A few details are all we need to start your free quote.

What you send us is only used to answer your enquiry and prepare a quote. It is not shared for marketing and we hold it for up to 12 months. Find out more in our privacy notice.

  • Quotes Are Free With no obligation

  • Insured Work Public and products liability

  • Family Run Lytham St Annes and the Fylde coast

  • Our Guarantee On every roofing job

Guttering & Fascias

How a roofline copes with life beside the Irish Sea

The parts of a roofline depend on each other. The gutter catches what runs off the tiles, the fascia board carries the gutter, and the soffit closes the gap under the eaves. When one part fails the others can soon follow. A blocked outlet sends water spilling behind the gutter, the fascia stays wet, and the rafter ends behind it can begin to rot. That is why the whole run gets checked before we recommend anything, rather than swapping the one length that happens to be dripping.

South-westerly gales are the obvious threat, driving rain along the eaves and working at any loose bracket. Salt is quieter. It settles on metal and feeds corrosion, so plain steel fixings rust sooner here than they would inland. Sand is the one people forget. Wind lifts it off the dunes that run north from St Annes, it settles in the bottom of the gutter, and unlike leaves it never floats away. Over time it cuts the capacity of the gutter and chokes the outlets.

Near the sea, materials do not all behave alike. Four are in common use. Salt does not attack uPVC, though uPVC expands in warm weather and needs room to move. Aluminium is light and its natural oxide layer helps it resist corrosion. Steel is strong, but at least one maker excludes coastal sites with high salt content from its warranty. Cast iron suits period houses but rusts unless the paint is kept up. We will go through the options for your property when we quote.

  • Gutter and downpipe replacement
  • Fascia and soffit renewal
  • Leaking joint and outlet repairs
  • Clearing sand, silt and moss
  • Resetting sagging gutter runs
  • Routine gutter maintenance
  • Commercial rooflines as well as houses
White fascia and soffit corner finished with a black gutter, a closer view relating to guttering and fascias

Signs to Look For

What to look for from the pavement

  • Green streaks down the brickwork

    A dark or green stain below the gutter usually marks a leaking joint or a run that overflows in heavy rain. Left alone, the wall stays wet, the pointing breaks down and damp can reach the inside of the building.

  • Flaking paint on fascia boards

    Blistered paint and soft timber usually mean water is getting behind the board. Brackets then lose their grip, and on an exposed road a loaded gutter can pull away in a gale. The rafter ends behind the fascia may also be affected.

  • Grass growing along the gutter

    Plants need something to root in, and along the Fylde that is often windblown sand mixed with moss and silt. By the time grass shows, the gutter has lost capacity and the outlet is probably restricted, so rain goes over the front instead of down the pipe.

Step by Step

Renewing a roofline, one stage at a time

  1. Check the run end to end

    Each length is checked for fall, joints and outlets, then the boards and the underlay at the eaves. Nothing is disturbed until we have looked for nesting birds, signs of bats and older boards that may contain asbestos.

  2. Decide what stays or goes

    You get our recommendation, and the reasons for it, in a free, no obligation quote. Rotten rafter ends or other repairs that come to light are talked through and priced apart from the roofline.

  3. Take down the old boards

    Old gutters and boards come down carefully so the timber behind can be seen. Where a cold roof draws air in at the eaves, that route is kept open, and sagging underlay is supported so water reaches the gutter.

  4. Fit, fall and test

    New boards and brackets go on using fixings picked for salt air. The gutter is laid with a fall towards its outlets, then we run water through it and check every joint.

Our Photos

The Kind of Roofing We Do

A selection of photos taken on our own roofing jobs.

  • Brick gable wall below a newly finished roof edge, photo from a job covering guttering and fascias
  • Finished tiled slope with a tidy edge along the gable, part of our guttering and fascias service
  • Freshly tiled roof with a line of bare trees behind, taken on a job involving guttering and fascias
  • New tiled slope seen from the scaffold boards at the eaves, one of our photos of guttering and fascias

Browse all our photos

Good to Know

Questions About Guttering & Fascias

Is capping over old fascia boards ever a good idea?

Only where the old timber is sound and dry. A capping board hides a problem without curing it, so rot left underneath carries on spreading and the fixings lose their hold. We check the existing boards and rafter ends first. If the timber is good, capping can be a fair option. If it is soft, it has to come off.

Why does our gutter overflow even after it has been cleared?

Check the fall first, because a sagging run holds water away from the outlet. With a sound fall, the gutter may be too small for the roof. Approved Document H sizes gutters from the effective roof area, and a 45 degree roof counts as one and a half times its plan area. A larger profile or an extra outlet usually solves it.

Could our old soffits or gutters contain asbestos?

They could if the building was built or refurbished before 2000. HSE lists asbestos insulating board or asbestos cement in soffits and fascias, and asbestos cement in gutters and downpipes. Do not drill, cut or break a suspect board. It needs identifying first, and asbestos insulating board generally has to be removed by an HSE licensed contractor.

Do nesting birds or roosting bats hold up eaves work?

They can, because work stops around them. It is an offence to intentionally damage or destroy a wild bird's nest while it is in use or being built, so an active nest means waiting until the young have gone. Bats are protected too, and they often roost behind soffits and fascias. If signs of bats appear, we pause and you will need advice from the National Bat Helpline or an ecologist.

Also Worth a Look

Other Work We Take On

  • Old tiled roof lifted back for repair work, roof repairs alongside guttering and fascias, all from one family firm

    Roof Repairs

    Slipped tiles, storm damage and stubborn leaks traced and put right.

  • Thick moss growing across rows of concrete tiles, roof cleaning alongside guttering and fascias, all from one family firm

    Roof Cleaning

    Moss and lichen cleared so your roof can shed water as it should.

  • Neat rows of red and brown roof tiles, pitched roofing alongside guttering and fascias, all from one family firm

    Pitched Roofing

    Re-roofs and new pitched roofs built for exposed coastal weather.

New red and brown tiles finished up against an older dark roof, free quotes for guttering and fascias with no obligation

Talk to Us About Guttering & Fascias

Your quote costs nothing and there is no obligation.