Grey slates being fixed in courses over red underlay, family run roofers offering slating

Family Run Fylde Coast Roofers

Slating in Lytham St Annes

Good slating comes down to nails, laps and battens, and wind and salt off the sea test all three.

  • A free quote and no obligation
  • Our owner started roofing at 17
  • A guarantee on all our work
  • Working across the Fylde coast

Your Free Roof Quote

A few details are all we need to start your free quote.

What you send us is only used to answer your enquiry and prepare a quote. It is not shared for marketing and we hold it for up to 12 months. Find out more in our privacy notice.

  • Quotes Are Free With no obligation

  • Insured Work Public and products liability

  • Family Run Lytham St Annes and the Fylde coast

  • Our Guarantee On every roofing job

Slating

What sea air asks of a slate roof

Natural slate is a durable stone, and on most old roofs the fixings give up long before the slates do. Corroded nails, known in the trade as nail sickness, let slates slide out of line, and failed batten nails can bring whole courses down the roof. Salt in the sea air hastens that corrosion. So a slate roof by the sea starts with a simple question. What is actually holding each slate in place, and will it cope with the air it sits in?

Exposure sets the rules for laying it. One major slate producer's guidance generally treats any site within 30 miles of a west facing coast as severe exposure, which takes in the whole of the Fylde. Head lap, the overlap that resists wind uplift and water creeping between slates, is worked out from the roof pitch and that exposure, and lower pitches need more of it. BS 5534 recommends a minimum pitch of 20 degrees for natural slate. The same producer recommends silicon bronze or stainless steel nails in coastal areas.

Slate is part of the character of old Lytham, and listed buildings such as the Lytham Institute have it on their roofs. Fylde Council also has conservation areas in Lytham and St Annes, including the Lytham Avenues and, in St Annes, Porritt Houses and Ashton Gardens. A repair should match the existing slate for type, colour, size and thickness. Look for replacements on the roof itself before anywhere else. A sound slate rings when tapped, while one that is failing sounds dull.

  • New natural slate roofs
  • Full strip and re-slate
  • Individual slates refixed or replaced
  • Slate matched to your property
  • Work on heritage and period properties
  • New battens, underlay and fixings
  • Ridge, verge and valley details
Slate roof and chimney stack under a clear blue sky, a closer view relating to slating

Signs to Look For

Repair a few slates or re-slate the roof?

  • A few slipped slates

    Isolated slipped or broken slates can usually be refixed or replaced on their own. Tingles, narrow metal strips that hold a slate's lower edge, are an accepted temporary repair, but they do nothing for failing nails elsewhere on the slope.

  • Around a fifth needing attention

    Conservation guidance suggests thinking about re-slating once roughly a fifth of the slates have been renewed, or when more than roughly 20 to 25 per cent are damaged or missing. Past that point, repairs tend to cost more than they save, and the fixings across the roof are likely to be failing too.

  • Rusted nails and weak battens

    Rusted nail heads, rust stains on the slates and battens weakened by damp or old nail holes all show the fixings are reaching the end. Sound slates can often come off and go back on, over new battens with fresh nails.

Step by Step

Setting out and laying a slate roof

  1. Judge what can be saved

    We inspect the slates, battens and nails, and check whether conservation controls apply. Our quote is free, carries no obligation and tells you how much of the existing slate we expect to reuse.

  2. Strip with reuse in mind

    Slates come off carefully so that sound ones can go back on. Damaged boards and battens are replaced and underlay goes on. Where the old roof had none, ventilation is planned at the same time, because underlay changes how the roof space behaves.

  3. Set out the courses

    Courses are marked to the batten gauge so the slates line up across the slope. Head lap comes from the pitch and the site's exposure, and it is only ever increased to suit the gauge, never reduced.

  4. Nail up and clear away

    Slates are nailed with fixings suited to a coastal site, with close attention at eaves, verges and ridges where wind does its worst. Once the debris is cleared, we talk you through the finished roof.

Our Photos

The Kind of Roofing We Do

A selection of photos taken on our own roofing jobs.

  • Slate slope viewed along the scaffold line, photo from a job covering slating
  • Freshly formed valley running down a slate roof beside the scaffold, part of our slating service
  • Slates trimmed back to a valley prepared with battens and membrane, taken on a job involving slating
  • Chimney stack rising over a slate roof with terraced houses beyond, one of our photos of slating

Browse all our photos

Good to Know

Questions About Slating

How many of my old slates can go back on?

Often at least some of them. Conservation bodies encourage reusing as many sound slates as possible, but one conservation guide warns not to expect to save more than half in most cases. Each slate is checked with a light tap, because a dull note suggests it is failing. Any shortfall is made up with matching slate, and new slates can be kept to the less prominent slopes.

Does a conservation area change the rules on re-slating?

It can, depending on the property. Replacing slate with matching slate often needs no planning application, but Article 4 directions cover parts of Lytham, including the Lytham Avenues, and remove some permitted development rights. Listing adds another layer, because work that affects a listed building's character needs listed building consent. Before ordering materials, get an answer for your exact address from your local council's planning team.

Natural slate or fibre cement, which should I choose?

They suit different jobs. Natural slate is quarried stone graded under BS EN 12326, and conservation bodies generally advise against artificial substitutes on older buildings. Fibre cement slates are factory made to different standards. Any laid before 2000 may contain asbestos, so identification has to come before anyone disturbs them. We can explain which would suit your roof.

Why do slate grades matter when choosing new slate?

Slates that look alike can perform very differently. BS EN 12326 grades them on water absorption, thermal cycling and resistance to sulphur dioxide. A W1 slate absorbs little water, which helps against frost damage and delamination, and T1 means no change in appearance after the thermal cycle test. Ask for those grades and the supplier's declaration of performance before you buy.

Also Worth a Look

Other Work We Take On

  • Close view of lead flashing stepped up a brick stack, lead work alongside slating, all from one family firm

    Lead Work

    Flashings, valleys and soakers dressed in sheet lead to suit the job.

  • Neat rows of red and brown roof tiles, pitched roofing alongside slating, all from one family firm

    Pitched Roofing

    Re-roofs and new pitched roofs built for exposed coastal weather.

  • New battens and underlay meeting a brick chimney, chimney repairs alongside slating, all from one family firm

    Chimney Repairs

    Stacks repointed, flashings renewed and loose pots made safe.

New red and brown tiles finished up against an older dark roof, free quotes for slating with no obligation

Talk to Us About Slating

Your quote costs nothing and there is no obligation.